Necessary knowledge of safe operation specificatio

Necessary knowledge of safe operation specifications of bottle blowing machine

1. Before starting up each shift, all moving parts must be lubricated once. (manipulator, manipulator guide rail, mold opening and closing guide rail)

2. The swing arm can be added once (34) days. The large chain and small chain of the heater can be used once a month. Frequently check whether the reducer of the main engine and the reducer of the heater are short of oil. The main engine bearing can be increased once (2 3) months

3. Before production, check whether the moving parts are firm, whether the screws are loose and fall off, especially in places with strong impact, and whether the belt transmission part is abnormal

4. check whether the high-pressure air source, low-pressure air source, power supply and water source are normal

5. Check whether all emergency stop switches, safety door switches and protective device detection switches are normal

6. check whether the heating head enters the embryo and whether the embryo dropping part works normally. If the embryo insertion is not in place, the nut of the embryo pressing device can be adjusted

7. check whether the lamp tube is damaged or broken. Replace it in time

8. check each pneumatic element 2.4 automatic storage: whether the automatic storage of experimental data and conditions leaks air and whether the action is sensitive

9. check whether the triplet leaks abnormally, whether it is blocked, and whether the water storage capacity of the water cup is too full

10. When the solenoid valve of the bottle blowing machine is abnormal, it should be cleaned in time (every 3.5 million bottles)

11. The bottle blowing mold must be cleaned and polished regularly

12. when opening the high and low pressure air source switch, you must act slowly to prevent the air flow rate from being too fast, and dirt from blowing into the solenoid valve. At the same time, open the exhaust valve for 30 seconds to ensure that the air is clean

13. when starting the machine, make sure that the mechanical part is in good condition, and there is no one inside the machine and no foreign matter. Especially the position of the handle to avoid hurting people. Close the safety door at the same time

14. when starting the machine, the motor must be started first, and a beneficial attempt has been made to upgrade the packaging and material experimental equipment. The heater must be started 30 seconds later to prevent voltage fluctuations. Make sure whether the cooling water is turned on before starting the heating

15. After heating and starting (2-3) minutes, in China's plastic machinery market, press the embryo button after the oven temperature rises evenly. At the same time, the bottle blowing should also be turned on when it is powered on, otherwise it will not blow the bottle

16. pay close attention to whether there is abnormal noise when the machine is running. It is necessary to find it early, stop it in time and solve it early

17. in case of emergency, press the emergency stop button, and the fermentation cycle of the tank will be shortened from 40 days to emergency braking within 10 days. Then analyze the causes according to the on-site situation, find the problems and solve them quickly

18. After the machine is in normal operation, do not stretch any part of the body into the machine to prevent the manipulator from hurting people. If the machine has abnormal noise, you can slow down and observe it

19. After the normal production of the machine, the operator must often observe the quality of bottles to avoid voltage fluctuations or other reasons affecting the quality of bottle blowing

20. During machine maintenance, press the touch screen fault maintenance button to ensure safe maintenance

if you need to manually observe the action of each mold cavity, please pay attention to the position of the manipulator. At the same time, we must be clear about the role of individual buttons, and then in the action. Ensure that the malfunction causes unnecessary trouble

21. After each repair of the machine, be sure to clean tools, screws and other things to avoid leaving them in the machine and affecting the normal operation of the machine